Floor Box cover with sleeve. Brass + Duplex for Wood.

The AP-RRP-2 is a recessed floor plate with a brass-plated cover. The back box is not included, use with an approved 2" x 3" box with a depth of 3.5". Inside the floor box is a single 15A duplex outlet, and the plugs are tamper proof. The sleeve in the box is adjustable up to 3/4" to accommodate any floor making installation a snap, screws are included to attach the plate to the receptacle box. The box may be attached directly to the floor or routed 3/4" into a finished floor. The box features two water-tight close-up screw plugs, and there is also a durable 1/16" neoprene rubber gasket that goes between the receptacles and plate. The receptacle is UL-listed and meets heavy-duty requirements for display receptacles. This floor box is a simple and economical solution to provide your power in a small and attractive plate.

Specifications:

• Plate: 1/8" Brass
• Outlet: One duplex 15A tamper proof
• 2 watertight screw plugs
• Must use your own backbox
• Adjustable up to 3/4"
• Attach to floor or route into a finished floor
• Includes 1/16" neoprene rubber gasket
• Outlet UL # E333616
• Meets NEMA WD1-1983 requirement
• Includes plate screws
• Cover size:  4 5/8" x 2 7/8"
• Cutout size: Can't exceed 2 1/8" x 3 1/2"
• Warranty:  1 year

 

  Click to view available Finishes
 

 

Please read our policy for refinishing floor box covers

 

Thank you for your interest in refinishing your floor box cover in one of our Arnev Products, Inc. custom finishes.  We ask that you follow these instructions to protect your cover.

 

1.  We ask that you send the COVERS ONLY.  Floor box covers generally come lacquer coated. To refinish the floor box covers, the lacquer must be removed, and this is done by soaking the covers in a strong chemical.  Any non-metallic parts that may be attached to the cover, including gaskets or electrical devices, receptacles, low voltage housings, etc., will also be dissolved with the lacquer. This is why we insist that only floor box covers be sent for refinishing.  If the cover or receptacle cannot be removed from the floor box, we cannot soak off the lacquer and refinish the cover.  Also, no plastic-type covers are accepted. We are NOT responsible for the box itself, gaskets, or devices, so please keep all the other parts to the assembly, take off the cover, and send only the cover. 

 

2.  Please package any exterior screws (screws that will be visible after the box is installed) with the cover so these can be finished to match the box.  Make sure they are secure so they don't get lost or scratch the cover in transit.

 

3.  Custom colors are run in batches.  Consequently, the finishing time can vary depending on the schedule for the batch of the custom color you have chosen.  However, as we need only the cover, the floor box itself can be installed by your electrician to maintain your building or remodeling schedule.

 

4.  You have been advised by one of our customer service representatives that the custom finishes are approved for LOW TRAFFIC AREAS ONLY.  Should you decide to install the floor boxes with our finished in HIGH TRAFFIC AREAS, any finishing 1-year limited warranty is void.  In addition, if you should decide to apply any protective finish (lacquer, polyurethane, etc.) OVER our custom finish, the finishing 1-year limited warranty is void.

 

5.  If you approve the enclosed sample and agree to the instructions above, please sign and return the top portion of this page.  You may keep the bottom portion for your records.

 

If you follow these instructions, we are confident that you will love your custom floor box covers and enjoy them for years to come.

 

I approve of sample number______________________________ and agree to these instructions.

 

X________________________________________________________________________________________________