First, is to place your order on our website at this page https://www.arnev.com/using-customers-own-wood-sent-to-us-for-manufacturing-.html, so we can see what you need us to make with your wood, and then we will email you how much wood is needed for the order.
Wood requirements for us to manufacture for you
You will need a min. 24" long so we can run it through the planer, and the width would depend on what you want us to manufacture.
Your wood must be a minimum of 1/2 thick, and if it is 1" thick or thicker, we can resaw it and get 2 boards.
All the wood we stock is 7/8 to 1" thick and we resaw it and get 2 boards.
WE WILL BE IN TOUCH WITH YOU TO TELL YOU HOW MANY BOARD FEET WE WILL NEED TO MANUFACTURE YOUR ORDER.
Once we know what you need us to make, we will send you the informtion to your email address you supplied along with this address where to send the wood:
Send to this address below:
Arnev Products, Inc.
C/O Jeremy Schmidt
2549 Burmeister Rd
Sturgeon Bay, WI 54235
This image was from a satisfied customer as we used their wood to make this switch plate cover for the beutiful side on the kitchen island:
Dan Herr
dan@countrysidewoodcraft.net
(413) 862-3276
Countryside Woodcraft


These are the available styles:

We also offer Cat 5-6. Telephone, Cable TV, and many other low voltage switch plates.
You will need to call 800-260-1181 for sending your wood to our company
All custom wood sizes are about 1/4 inch thick, much like a regular plastic switchplate.
Custom Wood Switchplate sizing:
|
|
One gang switchplates (Singles, Single Outlets, Single Groundfaults, Single Blanks, etc.) |
3 3/16" wide by 5" high |
Two gang switchplates (Doubles, Combo's, Double Groundfaults, Double blanks, etc.) |
5" wide by 5" high |
Three gang switchplates (Triples, Triple Groundfaults, Groundfault/Double Switch, etc.) |
6 13/16" wide by 5" high |
Four gang switchplates (Quad Switches, Outlet Cover/Triple Switch, etc.) |
9" wide by 5" high |
Five gang switchplates (5-Switch, 5-Groundfault/Rocker, etc.) |
10 13/16" wide by 5" high |
Six gang switchplates (6-Switch, 6-Groundfault/Rocker, etc.) |
12 5/8" wide by 5" high |
Seven gang switchplates (7-Switch, 7-Groundfault/Rocker, etc.) |
14 7/16" wide by 5" high |
Eight gang switchplates (8-Switch, 8-Groundfault/Rocker, etc.) |
16 1/4" wide by 5" high |